ASSEMBLE YOUR OWN
Assemble Your Own
Adirondack Chair
A Step-by-Step Guide
Tools/Materials Required:
Chair pieces - 29 in total - supplied
#8 x 1 ½” exterior screws (54) - supplied
#8 x 1 ¼” screws (8) - supplied
¼” x 2” galvanized carriage bolts (6) - supplied
¼” washer (6) - supplied
¼” nuts (6) - supplied
Exterior Wood Glue - supplied
#2 Robertson screwdriver (or hand drill with #2 Robertson bit)
7/16” wrench
Framing square (or try square)
1/ Line up both (A) SIDES on a workbench or flat surface as seen (image 1)
(ensure the best looking surfaces are facing out)
2/ Apply an even amount of glue to the top of both sides where the (B) BOTTOM BACK SUPPORT will sit. (image 2)
3/ Line up and insert the 4 screws to secure the (B) BOTTOM BACK SUPPORT to both A) SIDES as shown
(image 3 / image 4)
image 1
image 3
.jpg)
image 2
image 4
4/ Glue and screw the first (C) SEAT 1 piece (image 5 / image 6)
image 5
image 6
5/ Glue and screw the (D) FRONT as shown allowing approximately 3/8" gap. (Image 7)
image 7
6/ Line up, glue and assemble both (E) FRONT LEGS. (Images 8-11)
image 8
image 9
image 10
* Using a framing square, ensure the leg is 90 degrees to the floor or flat surface you are using to assemble.
image 11
More to come...